amontminy

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About amontminy

  • Rank
    Newbie
  1. Hello! I've recently been working on a drone project for university and have run into a couple of hurdles that I was hoping some of you may be able to help with. To start I've been using a Tarot x-8 frame using the CUAV Nano V5+ as a flight controller. A couple of the issues I've run into so far are. The landing gear is in the down position but because the switch shows the up position it will not allow take-off Is there any way to ensure that all of the motors are spinning at the same speed in software? We had a rather unsuccessful test flight that I will at