Search the Community
Showing results for tags 'inspire1'.
Found 6 results
-
Hello, I am selling my DJI Inspire 1 Pro with a Zenmuse X5 camera For $2,500 + Shipping or OBO. The drone has low hours on it and has never been crashed or flown away. The items included are listed below: DJI Inspire 1 Pro Zenmuse X5 DJI Inspire Hard Case Three DJI TB47 Batteries Three Freewell Camera Filters Two remote controls (Pilot & Camera) Two sets of Four Propellers (DJI 1345T) One Controller Harness One Charger Below is the link to the photos: (iPads not included) https://myalbum.com/album/rSp3CMS6FgHp Feel free to email me at joshualluellen@gmail.com.
-
Hi, Does anyone know what settings Pix4D Capture applies to the camera (Inspire 1 X3) when using the gridded flight mission? Last time I used it, I wasnt given the option to apply manual settings. Obviously I don't want Auto Exposure etc. applied. I am not sure what impact auto settings are having on the images Regards, Rylan
-
I have the Phantom 4 .. also the Sequoia cam, also investing in the thermals, high resolution cameras for use in survey mapping, search and recovery .. for both research and coursework / training (GIS / RMS, Pix4D, etc) . I am torn with the inspires as I dont think we can easily switch the cameras/ sensors on the Inspire2? Was leaning towards the Inspire1? I am also obtaining a couple of the Phantom4Pros in addition to the Inspires. We will primarily use units to generate orthos and surface models for remote sensing, watershed modeling ... Any suggestions?
-
No injuries sustained in this video
-
Hey all question for you, was flying in the mountains and had a strong gust of wind side swipe us and we hit a tree branch and fell only 8ft or so before it was all said and done , broke all the props but one and one of the quick connects shown below are shots of good and bad. I will absolutely change all of the props and throw the one away that was part of the crash. But should I replace all of the quick connects ?? or just the one that was toast as all the other ones I have inspected and they look fine. Just wanted to reach out for this one because the last thing I want is to have one of the others may have a small stress crack that I cant see and fail while I am in the air @ a couple hundred feet instead of a few feet. Thanks In Advance Ronk
-
All looking for a 3D mapping software for my Inspire1 Pro X5 has anyone had any luck with any apps, I know the SDK is still looming to be released for this bird but wanted to get some opinions
