Search the Community
Showing results for tags 'mikrokopter'.
Hey everyone, I’ve been flying dji drones for a long time, but I thought it was time to upgrade in order to carry my nicer DSLR cameras for my photo/video stuff. I was gifted an old Cinestar 8 with the mikrokopter electronics stack. I’m new to heavy lifters. I understand it’s going to need a lot of tuning, but I’m having some issues with it. I’ve gotten pretty comfortable flying manual but this is obviously not ideal on the job, so I’m trying to get the altitude and gps modes to be more reliable. I’ve calibrated the compass and gps, yet it has the tendency to drift around quite a bit, even though checking the compass and gps says it’s calibration is spot on and has great satellite communication. Also, altitude hold feels very unreliable. It’s obvious it’s trying to work, but it moves far too much to put me at ease. While the position hold is unreliable, I’m far less concerned with that as I am with altitude control, since precise elevation is crucial in areas I often have to fly. I’m curious if this drone is capable of being set up more like some of the smaller drones. As in, the copter once armed remains idle until throttle is lifted beyond a certain point. Then, on enabling alt hold, the throttle stick will switch to adjusting the speed of climb/descent rather than actual throttle. I’ve found the vario altitude hold, but this is still not quite the preferred behavior and still feels unreliable. Obviously I have a lot to learn, coming from mostly plug and play ready to fly systems. That being said, any help you guys can offer would be greatly appreciated!