Sign in to follow this  
00Hyla

Built finished, but having problems with hovering

Recommended Posts

Hi there, I've just finished my DIY drone, however I'm facing some problems while trying to hover. I have a Matek F722-SE-F7 flight controller, and sensor are looking fine in betaflight, but when I try to throttle up the drone doesn't hover properly. Slowly it goes on the right side and it goes up and down, it doesn't hover in place. This thing shows up drastically when I put off angle mode and air mode, I can't control my drone at all, and I'm afraid of crashing it.

Is this normal and I have to get used to it or do I have to configurate pids / sensors from betaflight?

 

PS. The drone is balanced enought, propellers are new as well as motors.

Share this post


Link to post
Share on other sites

So to clarify when you say it goes on the right side, do you mean it drifts to the right or do you mean like if will just flip to the right side and crash?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this